Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 463

Chapter 12: Configuring Point-to-Point Protocol over Ethernet
Ignore DF Bit—Enabled or disabled
Filter Option Packets—Router filters out packets with IP options; enabled or disabled
Administrative MTU—MTU size configured on the profile
TCP MSS value—Maximum segment size for TCP SYN packets traveling through the
interface
Inactivity Timer—Inactivity timer setting; enabled or disabled
Route Map Name—Route map applied to the IP interface subscriber; enabled or
disabled
Auto Detect—Router automatically detects packets that do not match any entries
in the demultiplexer table; enabled or disabled
Auto Configure—Dynamic creation of subscriber interfaces on a primary IP interface;
enabled or disabled
IGMP—Enabled or disabled
static-groups—Displays address of any static groups configured for IGMP
Input policy—Name of input policy and whether statistics are enabled or disabled
Output policy—Name of output policy and whether statistics are enabled or disabled
PPP Keepalive—PPP keepalive period, in seconds
PPP Magic Number—Enabled or disabled
PPP Peer DNS Priority—Enabled or disabled
PPP Peer WINS Priority—Enabled or disabled
PPP Authentication—Type of authentication configured: PAP, CHAP, or none
PPP Authentication Router—Name of authentication virtual router
PPP Negotiate MRU—MRU configured for the profile
PPP Packet Log—Enabled or disabled
PPP State Log—Enabled or disabled
PPP Chap Challenge Length—Minimum and maximum Chap Challenge length
PPP Passive Mode—Enabled or disabled
PPP Multilink—Enabled or disabled
PPP IPCP netmask option—Enabled or disabled
PPP AAA Profile—AAA profile associated with this PPP interface
Copyright © 2010, Juniper Networks, Inc. 431