Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 681

atm bulk-config
Copyright © 2010, Juniper Networks, Inc.
subinterfaces exist for any circuit on that subrange. The removal operation fails if any
such interfaces exist.
By default, the administrative state of a VC subrange is up. When you change the
administrative state to down by using the atm bulk-config shutdown command, the
router deletes all dynamic ATM 1483 subinterfaces on the affected subranges. You can
use the show atm subinterface command or the show atm vc command to monitor the
progress of the removal of all dynamic ATM 1483 subinterfaces for the specified subrange.
No additional dynamic ATM 1483 subinterfaces can be created for the subrange until
you restore the administrative state to up by using the no atm bulk-config shutdown
command.
The following example specifies the original VC subranges.
host1(config-if)#atm bulk-config test vc-range 1 1 101 150 vc-range 2 2 201 250 vc-range
5 5 501 550 vc-range 3 3 301 350
You cannot specify a partial subrange; the specified subrange must exactly match a
subrange that has already been configured. The following command changes the
administrative state of the second subrange (2, 2, 201, 250) to down. The router removes
all dynamic interface columns built on any of the circuits in this subrange. No additional
dynamic ATM 1483 subinterfaces can be created until you change the administrative
state to up.
host1(config-if)#atm bulk-config test shutdown vc-range 2 2 201 250
The following command changes the administrative state of this same VC subrange to
up.
host1(config-if)#no atm bulk-config test shutdown vc-range 2 2 201 250
You can change the administrative state of all subranges in a VC range at the same time
by issuing the command without specifying any subranges. The following command
shuts down all four subranges belonging to the named VC range, test, regardless of their
current state.
host1(config-if)#atm bulk-config test shutdown
The time required for the router to complete an administrative state change depends on
the number of VC subranges configured.
Use to create a bulk-configured VC range on a static ATM AAL5 interface for use by a
dynamic ATM 1483 subinterface.
For detailed information about how to use this command, see "atm bulk-config" on
page 637.
Example
host1(config)#atm bulk-config test1 vc-range 0 1 101 600
vc-range 3 5 201 3200
Use the no version to remove the specified VC range from the ATM AAL5 interface, to
remove the specified subranges from the specified VC range, or to remove all subranges
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
649