Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 320

JunosE 11.2.x Link Layer Configuration Guide
288
in-keepalive-requests—Number of received keepalive requests (LCP Echo
Requests)
out-keepalive-requests—Number of transmitted keepalive requests
in-keepalive-replies—Number of received keepalive replies
out-keepalive-replies—Number of transmitted keepalive replies
keepalive-failures—Number of keepalive failures reported on the interface
max-renegotiation-terminates—Number of renegotiation terminations for the PPP
session
IP protocol statistics
max-renegotiation-terminates—Number of times the link has been terminated
since it was created, due to the peer exceeding the maximum renegotiation
attempts.
IPv6 protocol statistics
max-renegotiation-terminates—Number of times the link has been terminated
since it was created, due to the peer exceeding the maximum renegotiation
attempts.
Authentication configuration
authenticate-retry—Maximum number of authentication retries configured using
the ppp max-bad-auth command
authentication-router—Virtual router for the authentication virtual router context
Authentication status
grant—Authentication status (true = access granted, false = access not granted)
session-timeout—Session timeout, in seconds; session is terminated at expiration
inactivity-timeout—Inactivity timeout, in seconds; session is terminated if it is not
active for specified timeout
accounting-timeout—Accounting timeout in seconds; frequency of accounting
updates to the authentication server
peer-ip-address—IP address to be used in negotiation of peer IP address
peer-ip-address-mask—IP address mask to be used in negotiation of the peer IP
address mask
peer-primary-dns-address—IP address to be used in negotiation of the peer primary
DNS address
peer-secondary-dns-address—IP address to be used in negotiation of the peer
secondary DNS address
Copyright © 2010, Juniper Networks, Inc.