Setting Statistics Baselines - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Setting Statistics Baselines

baseline bridge
baseline bridge interface
488
You can set a statistics baseline for a bridge group (by using the baseline bridge
command) or for a bridge interface (by using the baseline bridge interface command).
Use to set a statistics baseline for a specified bridge group.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Example
host1#baseline bridge westford03
There is no no version.
See baseline bridge.
Use to set a statistics baseline for a particular network interface belonging to a bridge
group.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
You must specify the following:
interfaceType—One of the following bridge interface types listed in Interface Types
and Specifiers in JunosE Command Reference Guide:
atm
fastEthernet
gigabitEthernet
tenGigabitEthernet
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers in JunosE Command Reference Guide for
information
Example
host1#baseline bridge interface atm 3/3.1
There is no no version.
See baseline bridge interface.
Copyright © 2010, Juniper Networks, Inc.