Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 715

show atm bulk-config
Copyright © 2010, Juniper Networks, Inc.
host1#show atm aal5 interface atm 3/0
AAL5 Interface ATM 3/0 operational status:
time since last status change: 00:08:46
SNMP trap link-status: disabled
Auto configure ATM 1483 status: disabled
InPackets: 0
InBytes: 0
OutPackets: 0
OutBytes: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
OutDiscards: 0
See show atm aal5 interface.
Use to display information, including base profile assignments and overriding profile
assignments, for the bulk-configured VC ranges on an ATM AAL5 interface.
To display information for all VC ranges on the router, use the command with no
keywords.
To display information for all VC ranges on a specified ATM AAL5 interface, use the
command with the atm keyword and interface specifier.
To display information for the VC range associated with a particular bulk configuration
name, use the command with the name keyword.
To display information for a particular VC range on a specified ATM AAL5 interface,
use the command with the atm keyword and interface specifier and the name keyword.
To display information only about overriding profile assignments configured for specific
ATM PVCs within bulk-configured VC subranges, use the command with the override
keyword. When you specify the override keyword, the command does not display
information about base profile assignments.
Field descriptions
Interface—Identifier of the ATM AAL5 physical interface on which the bulk-configured
VC range resides. For more information about specifying the ATM interface, see
Interface Types and Specifiers in JunosE Command Reference Guide.
Bulk Config Name—Name of the bulk-configured VC range on this interface
Start VPI—Starting virtual path identifier (inclusive) of the VC subrange
End VPI—Ending virtual path identifier (inclusive) of the VC subrange
Start VCI—Starting virtual circuit identifier (inclusive) of the VC subrange
End VCI—Ending virtual circuit identifier (inclusive) of the VC subrange
Assigned Profile—Base profile name for the dynamic ATM 1483 subinterface assigned
to this VC subrange with "profile atm1483 bulk-config-name" on page 645 . When no
profile is assigned to the VC subrange, the field displays none assigned.
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
lowerLayerDown
683