Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 648

JunosE 11.2.x Link Layer Configuration Guide
profile-reassign
616
10—The user can execute all commands except support commands, which may be
provided by Juniper Networks Customer Service.
15—The user can execute support commands.
Set a password for this mode by using either the enable password or the enable secret
command in Global Configuration mode. Doing so protects the router from any
unauthorized use.
After a password is set, anyone trying to use Privileged Exec mode is prompted to
provide the password.
Example
host1>enable 5
Password:*******
host1#
There is no no version.
See enable.
Use to reassign the profile currently assigned to the specified encapsulation type for
the specified ATM 1483 interface. For troubleshooting purposes, use the profile-reassign
command to swap the currently assigned profile for one that has PPP or PPPoE
packet–logging attributes enabled.
This command is available from Privileged Exec mode at privilege level 5 or higher.
Specify one of the following keywords:
ppp—Specifies a PPP encapsulation type to which the profile applies
pppoe—Specifies a PPPoE encapsulation type to which the profile applies
any—Specifies any autoconfigured encapsulation that does not have a specific
profile assignment; valid only if neither the ppp encapsulation type nor the pppoe
encapsulation type has an existing profile assignment
Specify a profile name of up to 80 alphanumeric characters.
Example 1—Facilitates debugging for the ppp encapsulation type by swapping profile
pppConfig for profile pppLogConfig, which includes PPP packet–logging attributes
host1#profile-reassign atm 2/0.101 ppp pppLogConfig
WARNING: Execution of this command will cause all dynamic interfaces over
atm 2/0.101 to be torn-down.
Proceed with profile reassignment? [confirm] yes
Profile pppConfig replaced by profile pppLogConfig for ppp.
Example 2—Facilitates debugging for the any encapsulation type by swapping profile
anyConfig for profile anyLogConfig, which includes both PPP and PPPoE packet–logging
attributes
host1#profile-reassign atm 3/0.101 any anyLogConfig
WARNING: Execution of this command will cause all dynamic interfaces over
atm 3/0.101 to be torn-down.
Copyright © 2010, Juniper Networks, Inc.