Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 124

JunosE 11.2.x Link Layer Configuration Guide
92
received—OAM loopback cell response received
failed—OAM loopback reply not received within frequency period, or reply contained
a bad correlation tag
OAM VC status:
AIS—VC is in AIS state
RDI—VC is in RDI state
Down Retry—OAM loopback failed; using retry frequency to verify that the VC is
really down
Down—OAM loopback failed after Down Retry verification
Up Retry—OAM loopback successful; using retry frequency to verify that the VC
is really up
Up—OAM loopback successful after Up Retry verification
Not Managed—VC integrity is not enabled; for more information about this status
value, see "Automatic Disabling of F5 OAM Services" on page 19
OAM loopback frequency—Frequency with which OAM loopback cells are transmitted
(when enabled), in seconds
OAM up retry count—Number of consecutive successfully looped OAM cells required
to mark the VC as Up
OAM down retry count—Number of consecutive unsuccessfully looped OAM cells
required to mark the VC as Down
OAM loopback retry frequency—Frequency with which OAM cells are transmitted in
verification mode, in seconds
OAM CC verification—Whether CC verification is enabled or disabled
OAM CC Type—Whether the VC is a sink or a source, or both sink and source end
point
OAM CC Flow Type—End-to-end or segment
OAM Current CC state
Ready—OAM CC is not enabled
Active—OAM CC cell flow is running
Activation Failed—OAM CC activation failed
Wait Activate—Waiting for interface to come up before the software sends the
activation request
Wait Activation Confirmation—Waiting for activation confirmation from the peer
Copyright © 2010, Juniper Networks, Inc.