JunosE 11.2.x Link Layer Configuration Guide
mpls
L2TP and Ethernet
156
host1(config-if)#ip address 192.6.129.5 255.255.255.0
(Optional) Configure additional PPPoE subinterfaces by completing Steps 5 through
8.
7 using unique numbering.
Figure 12 on page 156 illustrates this configuration.
Figure 12: Example of IP, MPLS, and PPPoE Stacking Configuration
Procedure
Use to enable, disable, or delete MPLS on an interface. MPLS is disabled by default.
Example
host1(config)#mpls
Use the no version to halt MPLS on the interface and delete the MPLS interface
configuration.
See mpls.
Most Ethernet interfaces support L2TP. To use L2TP, you must first create a PPP interface.
See L2TP Overview for information about configuring L2TP.
Copyright © 2010, Juniper Networks, Inc.