Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 588

JunosE 11.2.x Link Layer Configuration Guide
interface atm
profile
subscriber
556
Example 4—Either command reenables encapsulation type lockout for the bridged
Ethernet encapsulation type using the default lockout time range
host1(config-subif)#auto-configure bridgedEthernet
host1(config-subif)#no auto-configure bridgedEthernet lockout-time
Example 5—Permanently locks out the bridged Ethernet encapsulation type until the
auto-configure bridgedEthernet command is issued
host1(config-subif)#no auto-configure bridgedEthernet
Use the no version to terminate detection of the specified encapsulation type or, if the
lockout-time keyword is specified, to restore the lockout time range to its default value,
1–300 seconds.
See auto-configure.
Use to select an ATM interface or ATM 1483 subinterface.
For information about specifying the ATM interface or subinterface, see "interface atm"
on page 529.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 4/0/2
Use the no version to remove the interface or subinterface.
See interface atm.
Use to assign a profile.
You must specify the encapsulation type to which the profile applies: bridgedEthernet,
ip, ppp, pppoe , or any.
Specify a profile name with up to 80 alphanumeric characters.
Example
host1(config-subif)#profile bridgedEthernet foo
Use the no version to remove a profile assignment.
See profile.
Use to configure a local subscriber on the E Series router to support authentication
and configuration from RADIUS for a dynamic bridged Ethernet or IPoA interface.
For detailed information about how to use this command, see "subscriber" on page 552.
Example
host1(config-subif)#subscriber bridgedEthernet user-prefix charlie domain myisp
password-prefix lucy
Copyright © 2010, Juniper Networks, Inc.