Configuring Bridge Group Interfaces - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide
bridge snmp-trap link-status

Configuring Bridge Group Interfaces

bridge-group
476
bridge group can learn an unlimited number of MAC addresses, up to the maximum
number that the router supports.
Example
host1(config)#bridge westford05 learn 2000
Use the no version to restore the default value, 0 (zero) learned addresses.
See bridge learn.
Use to enable SNMP link status processing for a specified bridge group and to enable
SNMP traps for all bridge interfaces configured in the bridge group.
Example
host1(config)#bridge westford06 snmp-trap link-status
Use the no version to disable SNMP link status processing for the bridge group.
See bridge snmp-trap link-status.
To configure a bridge group interface:
From Global Configuration mode, select the ATM, Fast Ethernet, Gigabit Ethernet,
1.
or 10-Gigabit Ethernet interface or subinterface that you want to assign to the bridge
group.
Assign the interface or subinterface to an existing bridge group to create the bridge
2.
interface.
(Optional) Configure the bridge group interface as a trunk (server) interface.
3.
(Optional) Enable SNMP link status processing for the bridge group interface.
4.
(Optional) Set the maximum number of dynamic MAC addresses that the bridge
5.
group interface can learn.
For detailed sample configurations that include bridge interfaces, see "Configuration
Examples" on page 485.
Use to assign a bridge interface to an existing bridge group.
To create a subscriber (client) bridge group interface, which is the default, you must
supply the alphanumeric name of the bridge group (specified in the bridge command)
to which you want to assign the interface.
Optionally, you can also choose one of the following keywords:
subscriber-trunk—Creates a trunk (server) bridge group interface
Copyright © 2010, Juniper Networks, Inc.