Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 224

JunosE 11.2.x Link Layer Configuration Guide
show vlan subinterface
192
host1:vr2#show interfaces gigabitEthernet 2/0.1
GigabitEthernet2/0.1 is Up, Administrative status is Up
VLAN ID: 10, address 0090.5e00.0001
In: Bytes 2357, Packets 23
Multicast 0, Broadcast 0
Errors 0, Discards 0
Out: Bytes 4872, Packets 57
Multicast 0, Broadcast 0
Errors 0, Discards 0
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Example 2—Displays the status of a Gigabit Ethernet S-VLAN subinterface
host1:vr2#show interfaces gigabitEthernet 2/0.2
GigabitEthernet2/0.2 is Up, Administrative status is Up
SVLAN ID: 10, VLAN ID: 100, Ethertype 0x9100
In: Bytes 2357, Packets 23
Multicast 0, Broadcast 0
Errors 0, Discards 0
Out: Bytes 4872, Packets 57
Multicast 0, Broadcast 57
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
See show interfaces.
Use to display configuration and status information for a specified VLAN subinterface
or for all VLAN subinterfaces configured on the router.
Use the summary keyword to display only the counts of all VLAN subinterfaces and
VLAN major interfaces configured on the router.
Use the mac-address keyword to display information about the VLAN subinterfaces
that were configured with unique MAC addresses.
Use the vlan or svlan keywords to display information about specific S-VLAN IDs or
VLAN IDs.
Field descriptions
Interface—Type and specifier of the VLAN subinterface
Status—Status of the VLAN subinterface: up, down, dormant, lowerLayerDown,
absent
MTU—Maximum allowable size (in bytes) of the maximum transmission unit (MTU)
for the VLAN subinterface
Copyright © 2010, Juniper Networks, Inc.