Configuring Firewall; Chapter 15 Configuring Firewall; Configuring The Firewall Filter For Any Family Type (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

CHAPTER 15

Configuring Firewall

Configuring the Firewall Filter for Any Family Type (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring the Firewall Filter for Any Family Type (NSM Procedure) on page 159
Configuring the Firewall Filter for Bridge Family Type (NSM Procedure) on page 161
Configuring the Firewall Filter for Ccc Family Type (NSM Procedure) on page 163
Configuring Filters for inet Family Type (NSM Procedure) on page 165
Configuring Filters for inet6 Family Type (NSM Procedure) on page 170
Configuring the Firewall Filter for MPLS Family Type (NSM Procedure) on page 174
Configuring the Firewall Filter for VPLS Family Type (NSM Procedure) on page 177
Configuring a Policer for a Firewall Filter on page 180
You can specify any to filter packets based upon protocol-independent fields.
To configure firewall filter in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Firewall > Family >
3.
Any.
Add or modify settings as specified in Table 78 on page 160.
4.
Click one:
5.
OK-Saves the changes.
Cancel-Cancels the modifications.
159