Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 82

JunosE 11.2.x Link Layer Configuration Guide
oam cc
oam-pvc
50
host1(config-subif-atm-vc)#oam ais-rdi 5 10
host1(config-subif-atm-vc)#exit
Use the no version to restore the default values for the alarm down count and alarm
clear timeout duration.
See oam ais-rdi.
Use to enable F5 OAM CC verification on an ATM data PVC.
You can optionally specify one of the following values to configure CC cell flows:
segment—Opens an F5 OAM CC segment cell flow
end-to-end—Opens an F5 OAM CC end-to-end cell flow
You must specify one of the following values to enable CC verification:
source—Enables this VC as the source point (cell generator)
sink—Enables this VC as a sink point (cell receiver)
both—Enables this VC as both a sink point and a source point
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example 1—Enables CC verification with a source endpoint
host1(config-subif-atm-vc)#oam cc source
host1(config-subif-atm-vc)#exit
Example 2—Opens an F5 OAM CC segment cell flow and enables CC verification with
a sink endpoint
host1(config-subif-atm-vc)#oam cc segment sink
host1(config-subif-atm-vc)#exit
Use the no version to disable F5 OAM CC verification and restore the default setting
for cell termination, end-to-end.
See oam cc.
Use to enable generation of F5 OAM loopback cells on an ATM data PVC and, optionally,
enable F5 OAM VC integrity features on the circuit.
Use this command only on data PVCs configured with aal5snap, aal5autoconfig, or
aal5 mux ip encapsulation; the command is not valid for data PVCs configured with
other encapsulation types.
To enable F5 OAM VC integrity on the PVC, use the manage keyword.
You can optionally specify the number of seconds, in the range 1–600, for the router
to wait between the transmission of loopback cells during normal operation; the default
value is 10.
Copyright © 2010, Juniper Networks, Inc.