Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 730

JunosE 11.2.x Link Layer Configuration Guide
698
ATM1483 lockout (seconds)—Encapsulation type lockout setting for the specified
upper-interface encapsulation type (bridged Ethernet, IP, PPP, or PPPoE) configured
on a dynamic ATM 1483 subinterface
range—Minimum lockout time–maximum lockout time, in seconds
no lockout—Encapsulation type lockout is disabled
ATM1483 PVC circuit type—Encapsulation setting for the PVC configured on a
dynamic ATM 1483 subinterface
aal5autoconfig—Enables autodetection of the 1483 encapsulation (LLC/SNAP
or VC multiplexed)
aal5mux ip—VC-based multiplexed circuit for IP only
aal5snap—LLC encapsulated circuit; the LLC/SNAP header precedes the protocol
datagram
ATM1483 PVC service category—Service type setting for the PVC configured on a
dynamic ATM 1483 subinterface: UBR (the default), UBR PCR, NRT-VBR, RT-VBR,
or CBR
ATM1483 PVC Peak rate—Peak cell rate (PCR), in Kbps, for the PVC configured on
a dynamic ATM 1483 subinterfaces
ATM1483 PVC Avg rate—Average rate, in Kbps, for the PVC configured on a dynamic
ATM 1483 subinterface; also referred to as sustained cell rate (SCR)
ATM1483 PVC Burst size—Length in cells of the burst for the PVC configured on a a
dynamic ATM 1483 subinterface; also referred to as maximum burst size (MBS)
ATM1483 Description—Text description assigned to ATM 1483 subinterfaces that
are created with this profile
ATM1483 Advisory Rx Speed—Configured receive speed, in Kbps, for the dynamic
ATM 1483 subinterface. The E Series LAC sends this value to the LNS in the RX
Connect-Speed AVP [38].
ATM1483 PVC OAM Administrative status—Status of OAM F5 loopback cell
generation (for VC integrity) on a circuit created with this profile: enabled or disabled
ATM1483 PVC OAM Loopback frequency—Number of seconds between transmissions
of OAM F5 end-to-end loopback cells on a circuit created with this profile
ATM1483 Ip Subscriber information—Subscriber login information for the specified
dynamic interface type
ATM1483 Profile—Name of the profile assigned to the specified upper-interface
encapsulation type (bridged Ethernet, IP, PPP, or PPPoE); these profiles are
referenced in the base profile for a dynamic ATM 1483 subinterface as nested profile
assignments
Copyright © 2010, Juniper Networks, Inc.