Monitoring Subscriber Policies - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

Monitoring Subscriber Policies

show subscriber-policy
Copyright © 2010, Juniper Networks, Inc.
In Discards:
In Errors:
Out Octets:
Out Frames:
Out Discards: 0
Out Errors:
queue 0: traffic class best-effort, bound to bridge
FastEthernet9/1.1
Queue length 0 Bytes
Forwarded packets 0, Bytes 0
Dropped committed packets 0, Bytes 0
Dropped conformed packets 0, Bytes 0
Dropped exceeded packets 0, Bytes 0
Example 2—Uses the brief keyword to display a summary of all bridge interfaces
configured on the router
host1#show bridge westford01 interface brief
Interface
-----------------
FastEthernet9/1.1
FastEthernet9/1.2
FastEthernet9/3.1
ATM11/0.5
ATM11/3.2
ATM11/0.7
See show bridge interface.
You can use the show subscriber-policy command to display the rules for all subscriber
policies configured on your router or for a specified subscriber policy.
Use to display the set of forwarding and filtering rules for all default and nondefault
subscriber policies configured on the router or for a specified subscriber policy.
For all packet types except Relearn, the command displays permit to indicate that the
bridge interface forwards the packets, or deny to indicate that the bridge interface
filters the packets. (For information about the meaning of permit and deny for Relearn,
see the field descriptions.)
Field descriptions
Subscriber—Name of the subscriber policy
ARP—Specifies how the bridge interface handles ARP packets
Broadcast—Specifies how the bridge interface handles broadcast packets
Multicast—Specifies how the bridge interface handles multicast packets
Unknown Destination—Specifies how the bridge interface handles packets with
unknown unicast DAs
Unicast—Specifies how the bridge interface handles unicast (user-to-user) packets
Chapter 15: Configuring Transparent Bridging
0
0
0
0
0
Port Status
-------- ------------
1 Up
2 Up
3 Up
4 Up
5 Up
6 Up
499