Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 736

JunosE 11.2.x Link Layer Configuration Guide
704
Type—Type of VLAN subinterface
Static—VLAN or S-VLAN subinterface was configured statically
Dynamic—VLAN or S-VLAN subinterface was configured dynamically
Auto configure interface(s)—Types of dynamic upper interfaces configured with the
auto-configure command: IP or PPPoE
Detected dynamic interface—Type of dynamic upper interface detected during
autoconfiguration: IP, PPPoE, or (if no packet has been received) none
Interface types in lockout—Encapsulation types currently experiencing lockout: IP,
PPPoE, or none
Lockout state (seconds)—Settings of encapsulation type lockout for the upper-layer
encapsulation type indicated
Min—Minimum lockout time, in seconds
Max—Maximum lockout time, in seconds
Current—Current lockout time, in seconds; displays 0 (zero) if lockout is not
occurring
Elapsed—Time elapsed into the lockout time, in seconds; displays 0 (zero) if
lockout is not occurring
Next—Lockout time for the router to use for the next lockout event, in seconds
In—Analysis of inbound traffic on this interface
Bytes—Number of bytes received on the VLAN or S-VLAN subinterface
Packets—Sum of all unicast, broadcast, and multicast packets received on the
VLAN or S-VLAN subinterface
Multicast—Number of multicast packets received on the VLAN or S-VLAN
subinterface
Broadcast—Number of broadcast packets received on the VLAN or S-VLAN
subinterface
Errors—Total number of errors in all received packets; some packets might contain
more than one error
Discards—Total number of discarded incoming packets
Out—Analysis of outbound traffic on this interface
Bytes—Number of bytes sent on the VLAN or S-VLAN subinterface
Packets—Number of packets sent on the VLAN or S-VLAN subinterface
Multicast—Number of multicast packets received on the VLAN or S-VLAN
subinterface
Copyright © 2010, Juniper Networks, Inc.