Configuring Encapsulation For Data Pvcs - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

vbr-rt

Configuring Encapsulation for Data PVCs

Copyright © 2010, Juniper Networks, Inc.
PCR, in Kbps, in the range 0–149760 (for OC3 ATM modules) or 0–599040 (for
OC12 ATM modules)
SCR, in Kbps, in the range 0–149760 (for OC3 ATM modules) or 0–599040 (for
OC12 ATM modules)
Maximum burst size (MBS), in cells, in the range 0–16777215
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#vbr-nrt 50000 10000 150
host1(config-subif-atm-vc)#exit
Use the no version to restore the default service category, UBR without a PCR.
See vbr-nrt.
Use to configure the variable bit rate, real time (VBR-RT) service category on an ATM
data PVC.
You must specify all of the following parameters:
PCR, in Kbps, in the range 0–149760 (for OC3 ATM modules) or 0–599040 (for
OC12 ATM modules)
SCR, in Kbps, in the range 0–149760 (for OC3 ATM modules) or 0–599040 (for
OC12 ATM modules)
Maximum burst size (MBS), in cells, in the range 0–16777215
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#vbr-rt 200000 30000 400
host1(config-subif-atm-vc)#exit
Use the no version to restore the default service category, UBR without a PCR.
See vbr-rt.
The encapsulation method on a data PVC represents the format of the data units that
traverse the circuit. You can use the encapsulation command in ATM VC Configuration
mode to configure the encapsulation method for a data PVC, or to restore the default
encapsulation method, aal5snap.
For example, the following commands configure a data PVC that uses aal5all
encapsulation. Issuing the exit command causes the configuration to take effect.
host1(config)#interface atm 3/0.3
Chapter 1: Configuring ATM
47