Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 603

ipv6 http
ipv6 http redirectUrl
ipv6 mld
Copyright © 2010, Juniper Networks, Inc.
host1(config-profile)#ipv6 address 1::1/64
Use the no version to remove the IPv6 address from the interface.
See ipv6 address.
Use to create the HTTP local server to listen and process for IPv6 exception packets.
See Configuring the HTTP Server to Support Guided Entrance in the JunosE Broadband
Access Configuration Guide
Example
host1(config)#ipv6 http
Use the no version to delete the HTTP local server.
See ipv6 http.
Use to specify the URL to which a subscriber's HTTP access session is redirected.
The first access session is typically used by the Service Manager application to provide
initial provisioning and service selection for the subscriber.
HTTP redirect is per-interface; use the command in Interface, Subinterface or Profile
Configuration mode for static interfaces.
The redirect URL can be a maximum of 64 characters.
NOTE: The HTTP local server must be configured and enabled in the virtual router for
the interface on which you use the ipv6 http redirectUrl command. Otherwise, the URL
redirect operation will fail.
See Configuring the HTTP Server to Support Guided Entrance in the JunosE Broadband
Access Configuration Guide
Example
host1(config-if)#ipv6 http redirectUrl http://ispsite.redirect.com
Use the no version to restore the default, which disables the HTTP redirect feature.
See ipv6 http redirectUrl.
Use to enable MLD on an interface, and set the MLD version to MLDv2.
Example
host1(config-profile)#ipv6 mld
Use the no version to disable MLD on an interface.
See ipv6 mld.
Chapter 17: Configuring Dynamic Interfaces
571