Example 2: Bridging With Vlans - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Example 2: Bridging with VLANs

486
Configure a subscriber (client) bridge group interface over the bridged Ethernet
6.
interface as a peer to the PPPoE interface. Assign the interface to the bridge group
you created in Step 1.
host1(config-subif)#bridge-group westford01
The following example illustrates how to configure transparent bridging with VLANs over
a Fast Ethernet interface.
NOTE: You can also configure transparent bridging with VLANs over a bridged Ethernet
interface. For information, see "Configuring VLANs over Bridged Ethernet" on page 452
in "Configuring Bridged Ethernet" on page 443.
Create the bridge group.
1.
host1(config)#bridge westford02
Create a Fast Ethernet interface.
2.
host1(config)#interface fastEthernet 2/0
Create a VLAN major interface by specifying VLAN as the encapsulation method for
3.
the interface.
host1(config-if)#encapsulation vlan
Create a VLAN subinterface by adding a subinterface number to the interface
4.
fastEthernet command.
host1(config-if)#interface fastEthernet 2/0.1
Copyright © 2010, Juniper Networks, Inc.