Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 747

duplicate protection
disabled for
IWF PPPoE sessions, method of
processing..........................................................391
non-IWF PPPoE sessions, method of
processing..........................................................391
enabled for
IWF PPPoE sessions, method of
processing..........................................................391
non-IWF PPPoE sessions, method of
processing..........................................................391
for an underlying interface
PPPoE logical interface activation
and........................................................................391
for IWF PPPoE sessions
guidelines for configuring.................................391
of IWF PPPoE sessions
and access to network services.....................391
based on MAC addresses.................................391
guidelines for configuring.................................391
prevention of unauthorized access..............391
scenarios of configuration................................391
topologies for IWF PPPoE sessions
1:1 association between DSLAMs and the
B-RAS application.........................................392
N:1 association between DSLAMs and the
B-RAS application.........................................392
types of PPPoE sessions
with the IWF tag absent in PADR..................391
with the IWF tag present in PADR.................391
dying gasp
cases in which it occurs.............................................234
influencing the link state
using the bit in Flags field................................234
OAM remote failure detection
using Flags field in Information
PDUs...................................................................234
vendor-specific condition
notified constantly to the local
entity...................................................................234
dynamic encapsulation type lockout............................521
based on DSL Forum VSAs
for IWF PPPoE sessions...................................523
benefits.............................................................................521
configuring..................................................521, 528, 550
criteria used in determining
for IWF PPPoE sessions...................................523
Copyright © 2010, Juniper Networks, Inc.
for IWF PPPoE sessions
guidelines for configuring................................524
same as the behavior for non-IWF sessions,
scenario..............................................................524
sample configuration scenario......................525
single DSLAM connected to a B-RAS
device..................................................................525
with DSL Forum VSAs not present in
PADR...................................................................524
for PPPoE clients.........................................................544
clearing lockout condition...............................547
configuring............................................................544
differences from PPPoE over static
ATM.....................................................................544
monitoring...................544, 602, 603, 693, 694
grace period...................................................................523
guidelines........................................................................523
parameters used to perform
Agent-Circuit-Id...................................................523
Agent-Remote-Id...............................................523
MAC address........................................................523
Dynamic Host Configuration Protocol. See DHCP
relay
dynamic interfaces
ATM 1483 subinterfaces..................................518, 624
autodetection.......................................................512, 619
bridged Ethernet..........................................................553
authenticating subscribers...........519, 557, 632
configuring from a profile.....................514, 559, 620
configuring from RADIUS..........................................519
configuring IPoA..........................................................550
configuring Multiclass MLPPP................................352
configuring PPP and PPPoE over ATM................525
restarting LCP negotiations............................530
configuring PPPoE over static PPPoE..................531
ATM interface columns......................................531
encapsulation type lockout............................544
Ethernet and S-VLAN interface
columns.............................................................539
Ethernet and VLAN interface
columns.............................................................533
S-VLAN oversubscription.......................185, 539
static Ethernet interface columns................532
E120 and E320 routers......................................517, 623
E320 routers..................................................152, 170, 517
inserting dynamic IP routes intorouting
table..............................................................................519
monitoring...........................................................593, 682
oversubscription, ATM.......................................515, 621
Index
715