Configuring Ipv4 And Ipv6 Over Static And Dynamic Pppoe; Figure 51: Dynamic Pppoe Over Static Pppoe With Vlan Interface Columns - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Configuring IPv4 and IPv6 over Static and Dynamic PPPoE

534

Figure 51: Dynamic PPPoE over Static PPPoE with VLAN Interface Columns

To configure a VLAN subinterface to support a dynamic PPPoE subinterface:
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface.
1.
host1(config)#interface fastEthernet 4/1
Specify VLAN as the encapsulation method.
2.
host1(config-if)#encapsulation vlan
This command adds the VLAN major interface.
Create a VLAN subinterface by adding a subinterface number to the interface
3.
identifier.
host1(config-if)#interface fastEthernet 4/1.1
Assign a VLAN ID for the subinterface.
4.
host1(config-if)#vlan id 400
Set the encapsulation type to PPPoE.
5.
host1(config-subif)#encapsulation pppoe
Assign a profile.
6.
host1(config-subif)#pppoe profile pppoeProfile2
Configure the interface to detect and accept dynamic PPPoE subinterfaces.
7.
host1(config-subif)#pppoe auto-configure
You can configure IPv4 and IPv6 interface columns over static and dynamic PPPoE, as
shown in Figure 52 on page 535.
Copyright © 2010, Juniper Networks, Inc.