Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 710

JunosE 11.2.x Link Layer Configuration Guide
vlan bulk-config
vlan bulk-config modify
vlan bulk-config shutdown
678
host1(config-if)#vlan bulk-config test shutdown
The time required for the router to complete an administrative state change depends on
the number of VLAN subranges configured.
Use to create a bulk-configured VLAN range on a static VLAN major interface for use
by a dynamic VLAN subinterface.
For detailed information about how to use this command, see "vlan bulk-config" on
page 670.
Example
host1(config)#vlan bulk-config test1 svlan-range 200 250 2
Use the no version to remove the specified VLAN range from the VLAN major interface,
to remove the specified subranges from the specified VLAN range, or to remove all
subranges from the specified VLAN range. The no version also removes any overriding
profile assignments for VLAN IDs or S-VLAN IDs within the deleted VLAN range or
VLAN subrange.
See vlan bulk-config.
Use to expand or shorten the range of the specified VLAN subrange. You can modify
only a single specific subrange at a time.
You can expand a subrange if none of the added VLAN IDs or S-VLAN IDs overlap with
any other subrange. You can shorten a subrange if none of the dropped VLAN IDs or
S-VLAN IDs have existing dynamic VLAN subinterfaces. You can also modify an existing
subrange by configuring it to use agent-circuit-identifier information rather than a range
of VLAN IDs.
Modifying a subrange so that it completely includes at least one other subrange from
within the same VLAN range effectively merges the subranges. Each subrange that is
merged with another frees up a subrange for subsequent configuration. The subranges
that are merged do not need to be adjacent to each other.
The router retains any overriding profiles assigned to a subrange if the assignment falls
within the modified subrange. If the assignment falls outside of the newly modified
subrange, the router drops the overriding profile assignment. If two subranges are
merged, the router retains overriding profiles that were assigned to the separate
subranges and applies the overriding profiles to the newly merged subrange.
Example
host1(config-if)#vlan bulk-config test modify svlan-range 200 250 1 3
There is no no version.
See vlan bulk-config modify.
Copyright © 2010, Juniper Networks, Inc.