References; Configuring Atm 1483 Dynamic Subinterfaces - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

References

Configuring ATM 1483 Dynamic Subinterfaces

624
For more information about supported interface types and specifiers on E Series routers,
see Interface Types and Specifiers in JunosE Command Reference Guide.
For more information about RADIUS, consult the following resources:
DSL Forum Technical Report (TR)-101—Migration to Ethernet-Based DSL Aggregation
(April 2006)
RFC 2865—Remote Authentication Dial In User Service (RADIUS) (June 2000)
RFC 2866—RADIUS Accounting (June 2000)
RFC 3046—DHCP Relay Agent Information Option (January 2001)
E Series routers support configuration of dynamic ATM 1483 subinterfaces over static
ATM AAL5 interfaces over ATM. The dynamic ATM 1483 subinterface can perform
autodetection and dynamic creation of the following upper-layer encapsulation types:
Bridged Ethernet
IP
PPP
PPPoE
Figure 58 on page 625 shows the dynamic upper-interface columns supported by dynamic
ATM 1483 subinterfaces, and indicates which layers in the columns are static and dynamic.
Copyright © 2010, Juniper Networks, Inc.