Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 153

show frame-relay interface
Copyright © 2010, Juniper Networks, Inc.
Use to set a statistics baseline at the Frame Relay layer for multilink Frame Relay, POS,
serial or GRE tunnel interfaces, subinterfaces, or circuits.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Specify an interface or subinterface using the interface type and specifier. For more
information, see Interface Types and Specifiers in JunosE Command Reference Guide.
Specify a circuit using the interface type and specifier and the dlci keyword and the
dlci number.
You cannot set a baseline for groups of interfaces, subinterfaces, or circuits. You must
set baselines individually.
When baselining is requested, the time since the last baseline was set is displayed in
hours:minutes:seconds or days/hours format. If a baseline has not been set, the message
" No baseline has been set" is displayed instead.
The regular interface statistics and LMI statistics for interfaces are subject to the same
baseline timestamp. You cannot set separate baselines.
Use the optional delta keyword with Frame Relay show commands to specify that
baselined statistics are to be shown.
Example
host1#baseline frame-relay interface serial 2/0:1/1
host1#show frame-relay interface delta
Frame relay interface 2/0:1/1, status is lowerLayerDown
Number of interface down transitions is 0
Time since last status change 21:06:34
Number of configured circuits: 0
Time since last baseline 00:00:05
In bytes: 0
In frames: 0
In errors: 0
In discards: 0
In unknown protos: 0
There is no no version.
See baseline frame-relay interface.
Use to display statistics for the Frame Relay layer in a multilink Frame Relay, POS,
serial, or GRE tunnel interface.
Optionally, you can specify an interface using the interface type and specifier. For more
information, see Interface Types and Specifiers in JunosE Command Reference Guide.
Use the brief keyword to display the operational status of all configured interfaces.
Use the optional delta keyword to specify that baselined statistics are to be shown.
Field descriptions
Chapter 2: Configuring Frame Relay
Out bytes: 0
Out frames: 0
Out errors: 0
Out discards: 0
121