Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 701

vlan advisory-rx-speed
vlan advisory-tx-speed
vlan auto-configure
Copyright © 2010, Juniper Networks, Inc.
Use to specify the available Ethertypes that a packet must use to create a dynamic
VLAN subinterface.
Choose one of the following Ethertype values:
8100—Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
88a8—Specifies Ethertype value 0x88a8, as defined in draft IEEE Standard 802.1ad
9100—Specifies Ethertype value 0x9100
autoconfig—Specifies that the packet can use any Ethertype to create a dynamic
VLAN subinterface
Examples
host1(config-profile)#svlan ethertype 8100
host1(config-profile)#svlan ethertype autoconfig
Use the no version to restore the default value, autoconfig.
See svlan ethertype.
Use to set an advisory receive speed for VLAN subinterfaces that are created with the
profile you are configuring. This setting has no effect on data forwarding. You can use
it to indicate the speed of the client interface. When traffic is tunneled with L2TP, the
advisory receive speed is sent from the LAC to the LNS. See LAC Configuration
Prerequisites for additional information about the advisory receive speed.
The range is 0–2147483647 kbps; 0 indicates no advisory speed setting.
Example
host1(config-profile)#vlan advisory-rx-speed 2000
Use the no version to restore the default behavior—the Rx speed is not sent to the LNS.
See vlan advisory-rx-speed
Use to set an advisory connect speed for VLAN subinterfaces that are created with the
profile that you are configuring. This setting has no effect on data forwarding. You can
use it to indicate the speed of the client interface. When traffic is tunneled with L2TP,
the advisory receive speed is sent from the LAC to the LNS. See LAC Configuration
Prerequisites for additional information about the advisory receive speed.
The range is 0–2147483647 kbps; 0 indicates no advisory speed setting.
Example
host1(config-profile)#vlan advisory-tx-speed 2000
Use the no version to restore the default behavior—the Tx speed is not sent to the LNS.
See vlan advisory-tx-speed.
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
669