Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 526

JunosE 11.2.x Link Layer Configuration Guide
494
Aging Time—Length of time, in seconds, that a MAC address entry can remain in the
forwarding table
Learning—Whether acquisition of dynamically learned MAC addresses is currently
enabled or disabled
Max Learn—Maximum number of dynamic MAC addresses that the bridge group can
learn
Link Status Snmp Traps—Whether SNMP link status processing is enabled or disabled
for all bridge interfaces in the bridge group
Subscriber Policy—Name of the subscriber policy currently in effect for the bridge
group
Protocol Actions—When CRB is enabled, displays the protocols (IP, MPLS, or PPPoE)
for which explicit routing has been configured
Port Count—Number of ports (interfaces) currently configured for the bridge group;
this value typically matches the Interface Count
Interface Count—Number of bridge group interfaces currently configured for the
bridge group
Example 1—Displays the names of the bridge groups configured on your router
host1#show bridge groups
BridgeGroup: westford02
BridgeGroup: westford01
Example 2—Displays the configuration settings for each bridge group on your router
host1#show bridge groups details
BridgeGroup: westford02
Bridge Mode:
Aging Time:
Learning:
Max Learn:
Link Status Snmp Traps: Disabled
Subscriber Policy:
Protocol Actions:
Route IP
Route PPPoE
Port Count:
Interface Count:
BridgeGroup: westford01
Bridge Mode:
Aging Time:
Learning:
Max Learn:
Link Status Snmp Traps: Disabled
Subscriber Policy:
Protocol Actions:
Port Count:
Interface Count:
See show bridge groups.
CRB
300 secs
Enabled
Unlimited
client01
0
0
CRB
300 secs
Enabled
Unlimited
default Subscriber
1
1
Copyright © 2010, Juniper Networks, Inc.