Clearing The Lockout Condition For A Pppoe Client - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

pppoe auto-configure lockout-time
Copyright © 2010, Juniper Networks, Inc.
Client Address Current Elapsed Next
-------------- ------- ------- ----
0090.1a42.527c
0090.1a42.527c
For a description of the fields in the command display, see "show pppoe interface"
on page 602 and "show pppoe interface lockout-time" on page 603.
Use to specify the lockout time range for the PPPoE clients associated with the dynamic
PPPoE subinterface column on the static PPPoE major interface.
Dynamic encapsulation type lockout is disabled for PPPoE clients by default.
Configuring dynamic encapsulation type lockout temporarily prevents the static PPPoE
major interface from detecting, accepting, and creating dynamic PPPoE subinterface
columns until the lockout time expires.
Use the lockout-time keyword to set the minimum lockout time and maximum lockout
time, each of which can be in the range 1–86400 seconds (24 hours).
Use the none keyword to disable lockout for the PPPoE clients associated with the
dynamic PPPoE subinterface column on the static PPPoE major interface.
For information about the rules that apply when you configure the lockout time for
dynamic encapsulation type lockout, see "Guidelines for Configuring Encapsulation
Type Lockout for PPPoE sessions" on page 523.
Example 1—Enables dynamic creation of PPPoE subinterfaces on the static PPPoE
major interface using a nondefault lockout time range, 10–120 seconds
host1(config-subif)#pppoe auto-configure lockout-time 10 120
Example 2—Disables dynamic encapsulation type lockout for any PPPoE clients
associated with the dynamic PPPoE subinterface column on the static PPPoE major
interface
host1(config-subif)#pppoe auto-configure lockout-time none
Example 3—Terminates dynamic creation of PPPoE subinterfaces on the static PPPoE
major interface and, by extension, disables dynamic encapsulation type lockout for
this interface
host1(config-subif)#no pppoe auto-configure
Use the no pppoe auto-configure command to terminate dynamic creation of PPPoE
subinterfaces on the static PPPoE major interface.
See pppoe auto-configure.

Clearing the Lockout Condition for a PPPoE Client

You can use the pppoe clear lockout interface command to clear the lockout condition
for an individual PPPoE client associated with a dynamic PPPoE subinterface column
on a static PPPoE major interface. To identify the PPPoE client, you must specify its
source MAC address.
Chapter 17: Configuring Dynamic Interfaces
120 30 120
0 0 90
547