Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 721

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

Copyright © 2010, Juniper Networks, Inc.
Lockout state (seconds)—Settings of encapsulation type lockout for the upper-layer
encapsulation type indicated
Min—Minimum lockout time, in seconds
Max—Maximum lockout time, in seconds
Current—Current lockout time, in seconds; displays 0 (zero) if lockout is not
occurring
Elapsed—Time elapsed into the lockout time, in seconds; displays 0 (zero) if
lockout is not occurring
Next—Lockout time for the router to use for the next lockout event, in seconds
Assigned profile—For each dynamic interface type, indicates whether or not a profile
is assigned and, if assigned, displays the profile name
Subscriber info—Subscriber login information for the specified dynamic interface
type (bridged Ethernet or IP)
SNMP trap link-status—Trap link status: enabled or disabled
InPackets—Number of packets received on this interface
InBytes—Number of bytes received on this interface
OutPackets—Number of packets transmitted on this interface
OutBytes—Number of bytes transmitted on this interface
InErrors—Number of errors received on this interface
OutErrors—Number of outgoing errors on this interface
InPacketDiscards—Number of incoming packets discarded on this interface
InPacketsUnknownProtocol—Number of incoming packets with an unknown protocol
type
OutDiscards—Number of outgoing packets discarded on this interface
Example 1—Displays the current state of all ATM subinterfaces
host1#show atm subinterface
Interface
ATM-Prot VCD VPI VCI Type Encap MTU
----------- -------- --- --- --- ----- ----- ---- ------------- ---------
ATM 2/0.101 RFC-1483 101
ATM 2/0.102 RFC-1483 102
ATM 2/0.103 RFC-1483 103
3 interface(s) found
Example 2—Displays summary information for all ATM subinterfaces shown in Example
1
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
Circuit
0 101 PVC
AUTO
0 102 PVC
AUTO
0 103 PVC
AUTO
Interface
Status
Type
9180 dormantLockout Static
9180 up
Dynamic
9180 dormant
Static
689

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.2

Table of Contents