Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 439

service
Copyright © 2010, Juniper Networks, Inc.
This command accesses PPPoE Service Name Table Configuration mode, which
enables you to configure entries for the PPPoE service name table.
Example
host1(config)#pppoe-service-name-table myServiceTable1
Use the no version to remove the specified PPPoE service name table from the router.
See pppoe-service-name-table.
Use to add service name tags to the PPPoE service name table.
Each PPPoE service name table includes one empty service name tag, one unknown
service name tag, and can optionally include up to 16 additional custom service name
tags. An empty service name tag is used to represent any service. An unknown service
name tag is used to represent a service that has not been configured in the PPPoE
service name table. A custom service name tag is used to represent a specific service.
To modify the action associated with an empty service entry, use the
empty-service-name keyword with the action keyword. This directs the router to drop
PADI requests from the PPPoE client. The default action for an empty service name
entry is terminate.
To include a custom service entry, specify a serviceName of up to 31 alphanumeric
characters. Use the optional action keyword with the service command for a custom
service entry to specify that the router either drop or terminate PADI requests from
the PPPoE client. The default action for a custom service entry is terminate.
To modify the action associated with an unknown service entry, use the
unknown-service-name keyword with the action keyword. This directs the router to
terminate (allow) PADI requests from the PPPoE client. The default action for an
unknown service name entry is drop.
The default action for the unknown service name entry depends on the configuration
of the service name table. If all the services in the service name table are configured
to terminate, the default action of the unknown service name tag is drop. If all the
services in the service name table are configured to drop, the default action for the
unknown service name tag is terminate. If both terminate and drop are configured,
the default action for the unknown service name tag is drop.
Example 1– Includes a custom service entry in the PPPoE service name table. The
associated action for this service tag is terminate. This is the default action when you
add a custom service entry without using the optional action keyword.
host1(config-pppoe-service-name-table)#service myISPService
Example 2 – Includes a custom service entry in the PPPoE service name table. The
associated action for this service tag is drop. Use the optional action keyword with the
service command to associate an action with the custom service entry.
host1(config-pppoe-service-name-table)# service myQOSClass2 action drop
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
407