Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 361

Sample Display
Without Baseline
Copyright © 2010, Juniper Networks, Inc.
Use to set a statistics baseline for PPP interfaces—including MLPPP interfaces, either
individual serial (member link) interfaces or multilink (bundle) interfaces.
Use only the serial or mlppp keywords.
For serial interfaces, specify the interface location in the format
slot/port:channel/subchannel for CT3 modules.
For MLPPP interfaces, specify the interface location as the name of the MLPPP bundle.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
When baselining is requested, the time since the last baseline was set is displayed in
hours:minutes:seconds or days/hours format. If a baseline was not set, the following
message is displayed instead:
No baseline has been set
Use the optional delta keyword with MLPPP show commands to specify that baselined
statistics are to be shown.
Example
host1#baseline ppp interface serial 2/0:1/1
There is no no version.
See baseline ppp interface.
The following command displays PPP interface (including MLPPP interface) statistics
without baselining:
host1#show ppp interface statistics
PPP interface serial 2/0:4/1 is up
No baseline has been set
Interface statistics
packets
octets
errors
discards
PPP interface serial 2/0:5/1 is up
No baseline has been set
Interface statistics
packets
octets
errors
discards
PPP interface serial 2/1:4/1 is up
No baseline has been set
Interface statistics
packets
octets
errors
discards
PPP interface serial 2/1:5/1 is up
No baseline has been set
Interface statistics
packets
Chapter 9: Configuring Multilink PPP
in out
0 0
572 684
0 0
0 0
in out
0 0
572 684
0 0
0 0
in out
0 0
572 684
0 0
0 0
in out
0 0
329