Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 131

Chapter 1: Configuring ATM
InOamF4EndLoopbackCells—Number of F4 end-to-end loopback cells received
InOamF4EndLoopbackCommands—Number of F4 end-to-end loopback
commands received
InOamF4EndLoopbackResponses—Number of F4 end-to-end loopback responses
received
InOamF4EndAisCells—Number of F4 end-to-end AIS cells received
InOamF4EndRdiCells—Number of F4 end-to-end RDI cells received
InOamF4EndCCActDeActCells—Number of F4 end-to-end activation or
deactivation CC cells received
InOamF4EndCCCells—Number of F4 end-to-end CC cells received
OutOamF4EndCells—Number of F4 end-to-end CC cells transmitted
OutOamF4EndLoopbackCells—Number of F4 end-to-end loopback cells
transmitted
OutOamF4EndLoopbackCommands—Number of F4 end-to-end loopback
commands transmitted
OutOamF4EndLoopbackResponses—Number of F4 end-to-end loopback
responses transmitted
OutOamF4EndRdiCells—Number of F4 end-to-end RDI cells transmitted
OutOamF4EndCCActDeActCells—Number of F4 end-to-end activation or
deactivation CC cells transmitted
OutOamF4EndCCCells—Number of F4 end-to-end CC cells transmitted
Time since last status change—Time since last reported change to the end-to-end
OAM circuit status
Segment OAM CC verification—Enabled or Disabled
VP State—State of the VP: up, down
VP Oam State—OAM state of the VP: not managed (normal OAM state with no
OAM fault conditions), AIS, RDI
InOamF4SegmentCells—Number of F4 segment cells received
InOamF4SegmentCellsDropped—Number of incoming F4 segment cells that were
dropped
InOamF4SegmentLoopbackCells—Number of F4 segment loopback cells received
InOamF4SegmentLoopbackCommands—Number of F4 segment loopback
commands received
Copyright © 2010, Juniper Networks, Inc. 99