Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 444

JunosE 11.2.x Link Layer Configuration Guide
auto-configure
interface atm
pppoe service-name-table
profile
412
Example
host1(config-if)#atm pvc 10 100 22 aal5snap
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM 1483 subinterface to support a dynamic interface. Specifies
the type(s) of dynamic encapsulation that will be accepted/detected by the ATM 1483
subinterface.
This command causes the layers above ATM 1483 to become dynamic.
Select pppoe as the dynamic next upper interface type.
Example
host1(config-subif)#auto-configure pppoe
Use the no version to disable detection of the specified encapsulation.
See auto-configure.
Use to configure an ATM interface.
For information about specifying the ATM interface or subinterface, see "interface atm"
on page 388.
Examples
host1(config)#interface atm 3/0.1
host1(config)#interface atm 3/0/0.1
Use the no version to remove the interface or subinterface.
See interface atm.
Use from Profile Configuration mode to assign a PPPoE service name table to a profile
for use by the dynamic PPPoE interface column associated with the profile.
Specify the name of the PPPoE service name table configured with the
pppoe-service-name-table command from Global Configuration mode.
Example
host1(config-profile)#pppoe service-name-table myServiceTable1
Use the no version to remove the PPPoE service name table assignment.
See pppoe service-name-table.
Copyright © 2010, Juniper Networks, Inc.