Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 614

JunosE 11.2.x Link Layer Configuration Guide
ppp multilink multiclass fragmentation
ppp multilink multiclass reassembly
ppp multilink multiclass traffic-class
ppp passive-mode
ppp peer
582
host1 (config-profile)#ppp multilink multiclass multilink-classes 6
Use the no version to disable multiclass MLPPP or to restore the number of multilink
classes to the default value, 1.
See ppp multilink multiclass.
Use to enable fragmentation on a multilink class on a dynamic MLPPP interface.
Example
host1(config-profile)#ppp multilink multiclass fragmentation best-effort voice low-loss
video
Use the no version to disable fragmentation on a multilink class.
See ppp multilink multiclass fragmentation.
Use to enable reassembly on a multilink class on a dynamic MLPPP interface.
Example
host1(config-profile)#ppp multilink multiclass reassembly best-effort voice low-loss
video
Use the no version to disable reassembly on a multilink class.
See ppp multilink multiclass reassembly.
Use to configure mapping of QoS traffic classes to multilink classes on a dynamic
MLPPP interface.
Example
host1(config-profile)#ppp multilink multiclass traffic-class best-effort voice low-loss
video
Use the no version to delete the mapping of QoS traffic classes to multilink classes.
See ppp multilink multiclass traffic-class.
Use to force a static or dynamic PPP interface into passive mode before LCP negotiation
begins, for a period of one second. This delay enables slow clients to start up and
initiate the LCP negotiation.
Example
host1(config-profile)#ppp passive-mode
Use the no version to disable passive mode.
See ppp passive-mode.
Copyright © 2010, Juniper Networks, Inc.