Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 512

JunosE 11.2.x Link Layer Configuration Guide
mpls
multicast
pppoe
480
Use to modify the subscriber policy for IP to define whether a subscriber (client) bridge
interface permits (forwards) or denies (filters or drops) IP packets.
Specify one of the following keywords:
permit—Forwards packets of this type
deny—Filters or drops packets of this type
IP packets are forwarded by default.
Example
host1(config-policy)#ip deny
Use the no version to restore the default value.
See ip.
Use to modify the subscriber policy for MPLS to define whether a subscriber (client)
bridge interface permits (forwards) or denies (filters or drops) MPLS packets.
Specify one of the following keywords:
permit—Forwards packets of this type
deny—Filters or drops packets of this type
MPLS packets are forwarded by default.
Example
host1(config-policy)#mpls deny
Use the no version to restore the default value.
See mpls.
Use to modify the subscriber policy for the multicast protocol to define whether a
subscriber (client) bridge interface permits (forwards) or denies (filters or drops)
multicast packets.
Specify one of the following keywords:
permit—Forwards packets of this type
deny—Filters or drops packets of this type
Multicast packets are forwarded by default.
Example
host1(config-policy)#multicast deny
Use the no version to restore the default value.
See multicast.
Copyright © 2010, Juniper Networks, Inc.