Configuring F5 Oam For Data Pvcs; Table 7: F5 Oam Configuration Tasks And Associated Commands - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide
encapsulation

Configuring F5 OAM for Data PVCs

48
host1(config-subif)#pvc 6 0/250
host1(config-subif-atm-vc)#encapsulation aal5all
host1(config-subif-atm-vc)#exit
host1(config-subif)#
Use to configure the encapsulation method on an ATM data PVC.
Specify one of the following encapsulation types:
aal0—Causes the router to receive raw ATM cells on this PVC and forward the cells
without performing AAL5 packet reassembly
aal5all—Configures ATM over MPLS passthrough connections; the router passes
through all ATM AAL5 traffic without interpreting it
aal5autoconfig—Enables autodetection of the 1483 encapsulation (LLC/SNAP or
VC multiplexed)
aal5mux ip—Configures a VC-based multiplexed circuit used for IP only
aal5snap—Configures an LLC encapsulated circuit; an LLC/SNAP header precedes
the protocol datagram; this is the default encapsulation method
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#encapsulation aal5mux ip
host1(config-subif-atm-vc)#exit
Use the no version to restore the default encapsulation method, aal5snap.
See encapsulation.
In ATM VC Configuration mode, you can use the individual commands listed in Table 7
on page 48 to configure nondefault values for F5 OAM services.

Table 7: F5 OAM Configuration Tasks and Associated Commands

To Configure
Surveillance parameters for alarm indication
signal (AIS) and remote defect indication (RDI)
fault management cells
Continuity check (CC) verification
Generation of F5 loopback cells and enabling
of VC integrity
Parameters for VC integrity
Use This Command
oam ais-rdi
oam cc
oam-pvc
oam retry
Copyright © 2010, Juniper Networks, Inc.