Attaching A Qos Profile To An Interface; Attaching A Qos Profile To A Base Interface; Attaching A Qos Profile To An Atm Vp - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

JUNOSe 11.1.x Quality of Service Configuration Guide

Attaching a QoS Profile to an Interface

You can attach a QoS profile to the base of an interface hierarchy, to a specific ATM
VP or S-VLAN, or to a port type.
Tasks to attach a QoS profile include:

Attaching a QoS Profile to a Base Interface

You can attach a QoS profile to an interface at the base of an interface hierarchy.
Interface types below the attachment point cannot be referenced in the QoS profile.
To attach a profile to an interface:
1.
2.

Attaching a QoS Profile to an ATM VP

You can associate a QoS profile with all the ports of a certain interface type.
You can attach a QoS profile to an ATM VP. The profile applies to all VCs in the VP;
for example, the profile specifies the scheduler hierarchy of scheduler nodes and
queues for all VCs, IP interfaces, and L2TP sessions stacked above the VP.
To attach a profile to an ATM VP:
1.
2.
134
Attaching a QoS Profile to an Interface
qos-profile
queue
Attaching a QoS Profile to a Base Interface on page 134
Attaching a QoS Profile to an ATM VP on page 134
Attaching a QoS Profile to an S-VLAN on page 135
Attaching a QoS Profile to a Port Type on page 135
Enter Interface Configuration mode for the interface.
host1(config)#interface gigabitEthernet 2/0
Attach a QoS profile to the interface.
host1(config-if)#qos-profile qosp-ethernet-queuing
Enter Interface Configuration mode for the interface.
host1(config)#interface atm 1.0/1
Attach a QoS profile to the ATM VP.
host1(config-if)#atm-vp 50 qos-profile qosp-vp-strictbw