Omron CS1W-MCH71 MOTION CONTROL UNIT - 09-2004 Manual page 485

Interface Specifics
Timing Chart
Axis Control Bit:
ABS Origin Setting
Axis Status Bit:
Machine Origin
Axis Status Bit:
Busy
Axis Status Bit:
No Origin
Axis Status Bit:
Axis Operating
Axis Status Bit:
Positioning Completed
Word Variable
x+0 IW0440
- -
x+31 IW045F
Function
462
The bit [Positioning Completed] must be
ON when starting ABS origin setting.
1
0
1
0
1
0
1
0
1
0
1
0
T1
Bit
11 Axis Override Enable (Axis 1)
-
Axis Override Enable (Axis 32)
• Override is the function to change the feed rate specified in the motion
program or parameter to the user-specified speed with % specification.
• There are two types of override functions, [Task Override] and [Axis Over-
ride]. One of them is used in motion program execution depending on the
speed.
• The axis override can be applied to the speed specified by operand V in
the motion program or the speed set in the axis parameter.
T1
Name
Section 7-4
I/O
Output