Omron CS1W-MCH71 MOTION CONTROL UNIT - 09-2004 Manual page 316

Command Details
Description
Link Command execution
option completion
0 or omitted When slave axis travel distance
output is completed
1 When command execution is
started
2 When slave axis travel distance
output is completed
3 When command execution is
started
4 When slave axis travel distance
output is completed
5 When command execution is
started
8 When slave axis travel distance
output is completed
9 When command execution is
started
10 When slave axis travel distance
output is completed
11 When command execution is
started
12 When slave axis travel distance
output is completed
13 When command execution is
started
× 102)
Figures below the decimal point are to be omitted.
(6) When CAM table is specified: The greatest CAM data number in CAM ta-
ble
When specified with the global variable: 8188 (1FFC Hex)
When specified with the position data: 10238 (27FE Hex)
(7) There is no influence. ABL specification is always used.
• The synchronous operation is executed based on the CAM table specified
with CAM table number.
• The operands, CAM table number, Displacement data multiplier, Starting
data number, and Ending data number are handled in the same manner
as CAM command.
• Link distance specifies the master axis travel distance per phase cycle.
• Link option influences the following operations depending on the setting
value:
Link operation start
When command execution is
started
When command execution is
started
When latch for master axis is
detected
When latch for master axis is
detected
When master axis reaches Link
start position
When master axis reaches Link
start position
When command execution is
started
When command execution is
started
When latch for master axis is
detected
When latch for master axis is
detected
When master axis reaches Link
start position
When master axis reaches Link
start position
Section 6-3
Repeat
Repeat
Repeat
Repeat
Repeat
Repeat
Repeat
Only for one cycle from the starting
to ending data number
Only for one cycle from the starting
to ending data number
Only for one cycle from the starting
to ending data number
Only for one cycle from the starting
to ending data number
Only for one cycle from the starting
to ending data number
Only for one cycle from the starting
to ending data number
293