Table of Contents
Advertisement
Routing
6. Create a packet filtering rule that rejects all other LAN packets on the cellular WAN interface:
a. Create a new packet filtering rule:
i. Type ... to move to the root of the configuration:
(config network route policy 0)> ...
(config)>
ii. Create the packet filtering rule:
(config)> add firewall filter end
(config firewall filter 2)>
b. Set the lable to Reject LAN traffic to cellular WAN:
(config firewall filter 2)> label "Reject LAN traffic to cellular WAN"
(config firewall filter 2)>
c. Set the action to drop:
(config firewall filter 2)> action drop
(config firewall filter 2)>
d. Set the source zone to internal:
(config firewall filter 2)> src_zone internal
(config firewall filter 2)>
e. Set the destination zone to CellularWAN:
(config firewall filter 2)> dst_zone CellularWAN
(config firewall filter 2)>
7. Save the configuration and apply the change:
(config firewall filter 2)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Routing services
Your TX54 includes support for dynamic routing services and protocols. The following routing services
are supported:
Service or
protocol
RIP
TX54 User Guide
Information
The IPv4 Routing Information Protocol (RIP) service supports RIPv2 (
RFC1058
and RIPv1 (
).
IP routing
RFC2453
)
364
Advertisement
Table of Contents
