Table of Contents
Advertisement
Wi-Fi
a. Click Configuration > Network > Interfaces.
b. For Add interface, type a name for the LAN and click .
c. For Zone, select LAN2_isolation_zone.
d. For Device, select the new Wi-Fi access point or, for dual-Wi-Fi models, if you are using
both of the preconfigured access points rather than creating a new access point, select Wi-
Fi access point: Digi AP (Wi-Fi2).
e. Click to expand IPv4.
f. For Address, type an IP address and subnet for the LAN.
g. Click to expand DHCP server.
h. Enable the DHCP server.
6. Remove the Digi AP (Wi-Fi2) access point from the LAN1 bridge:
This step applies to dual-Wi-Fi models only, and only if you are using both preconfigured
access points, rather than creating a new access point.
a. Click Network > Bridges > LAN1.
b. Click the down arrow () next to the the Digi AP (Wi-Fi2) access point and select Delete.
7. Click Apply to save the configuration and apply the change.
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX54 User Guide
Isolate Wi-Fi clients
269
Advertisement
Table of Contents
