Table of Contents
Advertisement
Firewall
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable web filtering:
(config)> firewall web-filter enable true
(config)>
4. Set the web filter service type to umbrella:
(config)> firewall web-filter service umbrella
(config)>
5. Set umbrella_token to the API token generated in
token:
(config)> firewall web-filter umbrella_token token
(config)>
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Clear the Cisco Umbrella device ID
If the Cisco Umbrella device ID being used by your TX54 is invalid, you can clear the device ID.
Command line
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX54 User Guide
Task one: Generate a Cisco Umbrella API
Web filtering
833
Advertisement
Table of Contents
