Digi TX54 User Manual page 692

Applications
network.interface.lan1.enable=true
network.interface.lan1.ipv4.address=192.168.2.1/24
network.interface.lan1.ipv4.connection_monitor.attempts=3
...
b. Print a list of available interfaces:
>>> cfg = config.load()
>>> interfaces = cfg.get("network.interface")
>>> print(interfaces.keys())
This returns the following:
['defaultip', 'defaultlinklocal', 'lan1', 'loopback', 'wan1', 'wwan1',
'wwan2']
c. Print the IPv4 address of the LAN interface:
>>> cfg = config.load()
>>> interfaces = cfg.get("network.interfaces")
>>> print(interfaces.get("lan.ipv4.address"))
Which returns:
192.168.2.1/24
Modify the device configuration
Use the set() and commit() methods to modify the device configuration:
1. Log into the TX54 command line as a user with shell access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type shell to access the device shell.
2. At the shell prompt, use the python command with no parameters to enter an interactive
Python session:
# python
Python 3.6.13 (default, May
[GCC 8.3.0] on linux
Type "help", "copyright", "credits" or "license" for more information.
>>>
3. Import the config submodule:
>>> from digidevice import config
>>>
4. Use config.load(writable=True) to enable write mode for the configuration:
>>> cfg = config.load(writable=True)
>>>
TX54 User Guide
9 2021, 22:49:59)
Digidevice module
692