Digi TX54 User Manual page 114

Interfaces
Move the TX54 device to another location.
n
Try connecting a different set of antennas, if available.
n
Purchase a Digi Antenna Extender Kit:
n
Antenna Extender Kit, 1m
l
Antenna Extender Kit, 3m
l
AT command access
To run AT commands from the TX54 command line:

Command line
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type modem at-interactive and press Enter. Type n if you do not
want exclusive access. This allows you to send AT commands to the device while still allowing
the device to connect, disconnect, and/or reconnect to the cellular network.
3. At the Admin CLI prompt, use the
command session:
> modem at-interactive
Do you want exclusive access to the modem?
If the device has more than one modem, identify the modem by name, for example:
> modem at-interactive name wwan1
Do you want exclusive access to the modem?
4. Type n if you do not want exclusive access. This allows you to send AT commands to the
device while still allowing the device to connect, disconnect, and/or reconnect to the cellular
network.
The following is an example interactive AT command:
> modem at-interactive name wwan1
Do you want exclusive access to the modem? (y/n) [y]: n
Starting terminal access to modem AT commands.
Note that the modem is still in operation.
To quit enter '~.' ('~~.' if using an ssh client) and press ENTER
Connected
ati
Manufacturer: Sierra Wireless, Incorporated
TX54 User Guide
modem at-interactive command to begin an interactive AT
(y/n) [y]:
(y/n) [y]:
Wide Area Networks (WANs)
114