Digi TX54 User Manual page 247

Wi-Fi
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Edit an existing Access point
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Show available access points:
(config)> network wifi ap ?
Additional Configuration
------------------------------------------------------------------------
-------
digi_ap1
digi_ap2
(config)>
4. Set the SSID for the appropriate access point:
(config)> network wifi ap digi_ap1 ssid my_SSID
(config)>
5. SSID broadcasting is enabled by default for the preconfigured access points. If SSID
broadcasting is disabled:
(config)> network wifi ap digi_ap1 ssid_broadcast true
(config)>
6. Set the security for the access point to an open security method:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is either:
none: No encryption is used.
n
owe: Uses WPA3 Enhanced Open, which uses Opportunistic Wireless Encryption (OWE)
n
technology to provide encryption for Wi-Fi networks that do not use password
protection.
Note
have WPA3 capabilities.
TX54 User Guide
Digi AP (Wi-Fi1)
Digi AP (Wi-Fi2)
Only select owe if you know that all Wi-Fi clients connecting to this device will
Configure an open Wi-Fi access point
247