Digi TX54 User Manual page 169

Interfaces
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click to expand an existing LAN, or create a new LAN. See
5. Click to expand IPv4 > DHCP server > Advanced settings > Static leases.
6. For Add Static lease, click .
7. Type the MAC address of the device associated with this static lease.
8. Type the IP address for the static lease.
Note The IP address here should be outside of the DHCP server's configured lease range. See
Configure a DHCP server
9. (Optional) For Hostname, type a label for the static lease. This does not have to be the
device's actual hostname.
10. Repeat for each additional DHCP static lease.
11. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX54 User Guide
for further information about the lease range.
Local Area Networks (LANs)
Configure a LAN.
169