Digi TX54 User Manual page 366

Hide thumbs Also See for TX54:

Table of Contents

4. Click Enable.

The default firewall zone setting, Dynamic routes, is specifically designed to work with routing

services and should be left as the default.

5. Configure the routing services that will be used:

a. Click to expand a routing service.

b. Enable the routing service.

c. Complete the configuration of the routing service.

6. Click Apply to save the configuration and apply the change.

Command line

1. Log into the TX54 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Enable routing services:

(config)> network route service enable true

4. Configure routing services that will be used:

a. Use the ? to display available routing services:

(config)> network route service ?

Routing services: Settings for dynamic routing services and protocols.

---------------------------------------------------------------------

TX54 User Guide

Current Value