Digi TX54 User Manual page 207

Serial port
The default is Login.
5. (Optional) For Label, enter a label that will be used when referring to this port.
6. Expand Serial Settings.
a. For Baud rate, select the baud rate used by the device to which you want to connect.
b. For Data bits, select the number of data bits used by the device to which you want to
connect.
c. For Parity, select the type of parity used by the device to which you want to connect.
d. For Stop bits, select the number of stop bits used by the device to which you want to
connect.
e. For Flow control, select the type of flow control used by the device to which you want to
connect.
7. Expand Data Framing Settings.
a. Click Enable to enable the data framing feature.
b. For Maximum Frame Count, enter the maximum size of the packet. The default is 1024.
c. For Idle Time, enter the length of time the device should wait before sending the packet.
d. For End Pattern, enter the end pattern. The packet is sent when this pattern is received
from the serial port.
e. Click Strip End Pattern if you want to remove the end pattern from the packet before it is
sent.
TX54 User Guide
Configure UDP serial mode
207