Digi TX54 User Manual page 395

Routing
Task 5: Configure the DHCP server for LAN1 on device two
1. Click to expand Network > Interfaces > LAN1 > IPv4 > DHCP Server
2. For Lease range start, type 200.
3. For Lease range end, type 250.
4. Click Advanced settings.
5. For Gateway, select Custom.
6. For Custom gateway, enter 192.168.3.3.
7. Click Apply to save the configuration and apply the change.

Command line
Task 1: Configure VRRP on device two
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create the VRRP instance:
(config)> add network vrrp VRRP_test
(config network vrrp VRRP_test)>
4. Enable the VRRP instance:
(config network vrrp VRRP_test)> enable true
(config network vrrp VRRP_test)>
5. Set the VRRP interface to LAN1:
(config network vrrp VRRP_test)> interface /network/interface/lan1
(config network vrrp VRRP_test)>
TX54 User Guide
Virtual Router Redundancy Protocol (VRRP)
395