Web Filtering; Configure Web Filtering With Cisco Umbrella - Digi TX54 User Manual

Firewall
Repeat to add a new rule. Up to 30 rules can be configured.
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Web filtering

Web filtering allows you to control access to services that can be accessed through the TX54 device by
forwarding all Domain Name System (DNS) traffic to a web filtering service. This allows the network
security administrator to configure a set of policies with the web filtering service that are applied to
all routing devices with web filtering enabled. For example, a policy may allow or deny access to a
specific service or type of service such as social media, gaming, and so on.
Your TX54 device supports two methods for configuring web filtering:
Cisco Umbrella (formally known as OpenDNS).
n
Manual DNS server entry.
n

Configure web filtering with Cisco Umbrella

Required configuration items
Enable web filtering.
n
A Cisco Umbrella account.
n
See https://umbrella.cisco.com
A 14 day trial account is available.
A customer-specific API token.
n
TX54 User Guide
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
address6: Only traffic destined for the IP address typed in IPv6 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
for information about how to create a Cisco Umbrella account.
Web filtering
831