Digi TX54 User Manual page 270

Wi-Fi
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure a new access point:
a. Create a new access point:
(config)> add network wifi ap new_AP
(config network wifi ap new_AP)>
New access points are enabled by default.
b. Set the Wi-Fi radio for the new access point:
i. Show available radios:
(config network wifi ap new_AP)> radio ?
Radio: The Wi-Fi radio to run this access point on.
Format:
Current value:
(config network wifi ap new_AP)>
ii. Set the appropriate radio:
(config network wifi ap new_AP)> radio wifi1
(config network wifi ap new_AP)>
c. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
d. Set the security for the access point:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is one of:
n
n
n
n
e. Complete other encryption-related fields as appropriate based on the type of encryption.
See Configure an open Wi-Fi access
security, or
TX54 User Guide
wifi1
wifi2
none
psk
psk2
wpa2:
Configure a Wi-Fi access point with enterprise security
point, Configure a Wi-Fi access point with personal
Isolate Wi-Fi clients
for details.
270